Go to the left hand side tab and click on the “ANALYSIS AND ANNOTATION” tab and select the “CURRENT” to place the ammeter and select the “voltage ” to place the voltmeter. Next we are going to place an ammeter and a voltmeter in the circuit. ANY circuit without any ground source is virtually incomplete. Place the”GROUND” on arbitrary site on the circuit. Next select the “GROUND” from “SCHEMATIC CONNECTOR” tab. join the terminals of the resistors in series and the voltage source in series by placing the cursor on the terminals and drawing out wires by pressing the left mouse button and dragging it to the nearest terminal. place the DC voltage source at a suitable position. The cursor of the mouse will begin to carry the resistor,place the resistor on a suitable grid line.Follow the same steps for second resistor and join it on same grid line previous one.then we go select the “sources” tab on the left hand side toolbar,then select the DC voltage.
SERIES RESISTANCE CIRCUIT FIRST,We go to the left hand side toolbar the left click on the”passive” Tab,then select the resistance. In this blog we are going to discuss on how to work in multisim 14.2.We are going to see how to create series and parallel resistance circuit and analyses the various circuit parameter of the respective circuit. “Software is a gas it expands to fill its container” _ Natham Myhrvold.
